沥青浸渍炭化C/ C 复合材料密度及孔隙分布

首页 > 过刊浏览>2014年第44卷第6期 >

沥青浸渍炭化C/ C 复合材料密度及孔隙分布
DOI:
                        
                    
CSTR:
                        [cstr]
                    
作者:
                        
                        
                    
作者单位:西安航天复合材料研究所
作者简介:
通讯作者:
中图分类号:TB3
基金项目:

Distribution of Density and Pores of C/ C Composite Prepared byPitch Impregnation and Carbonization

Author:

Affiliation:

Fund Project:

摘要

图/表

访问统计

参考文献

相似文献

引证文献

资源附件

文章评论

摘要:

以径棒法编织成型预制体,采用沥青浸渍炭化工艺制备了C/ C 复合材料(1. 50 g/ cm3 ),采用CT

检测了试件的密度分布特征,并采用光学显微镜和压汞法分析了试件的孔隙分布特征。结果表明,在沥青浸渍

炭化的工艺条件下,试件外端密度最高,由外端到中心沿径向密度递减;以坯体中心为参照点,同一圆周方向密

度均匀分布;坯体开孔率沿径向由外端到中心递增;坯体大孔和中孔孔容积比率沿径向从外端到中心递增,而

微孔孔容积比率则从外端到中心递减。

Abstract:

By taking preform weaven with radial carbon rods as reinforcement phase, C/ C composite was prepared

by impregnation and carbonization process using coal tar pitch as matrix precursor, and its bulk density is 1． 50

g/ cm3. The distribution of density was tested by CT, and the distribution of pores were analyzed by means of optical

microscope and mercury intrusion method. The results showed that the density of outer fringe of body is the highest,

and the density decreased from outboard to center along radial of the body under the technological conditions of pitch

impregnation and carbonization. The density distributed evenly along the direction of identical circle taking body center

as reference point. The porosity of the body increased from outboard to center along radial of the body. The pore

volume ratio of macropores and mesopores increased from outboard to center along radial of the body, on the contrary,

the pore volume ratio of micropores decreased from outboard to center along radial of the body .

参考文献

相似文献

引证文献

引用本文

周绍建.沥青浸渍炭化C/ C 复合材料密度及孔隙分布[J].宇航材料工艺,2014,44(6).

复制

文章指标

点击次数:
下载次数:
HTML阅读次数:
引用次数:

历史

收稿日期:
最后修改日期:
录用日期:
在线发布日期: 2016-11-28
出版日期:

期刊介绍

编委会

投稿须知

引用本文

分享

文章指标

历史

文章二维码