Cu、Li 含量对Mg、Ag、Zn 复合微合金化铝锂合金力学性能及微观组织的影响
DOI:
作者:
作者单位:

中南大学材料科学与工程学院

作者简介:

通讯作者:

中图分类号:

TG14

基金项目:


Influence of Cu and Li Contents on Mechanical Properties andMicrostructures of Mg鄄, Ag鄄and Zn鄄Microalloyed Al-Li Alloys
Author:
Affiliation:

Fund Project:

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献
  • |
  • 相似文献
  • |
  • 引证文献
  • |
  • 资源附件
  • |
  • 文章评论
    摘要:

    通过18 个不同Cu (3. 24% ~4. 16%)、Li (0. 94% ~1. 44%)含量的0. 4Mg+0. 4Ag+0. 4Zn 复合
    微合金化Al-Cu-Li 合金,研究总结了T8 时效处理时Cu 含量及Li 含量对铝锂合金强度和微观组织的影响,并
    采用合金中非固溶Cu、Li 原子总分数及Cu/ Li 原子分数比例阐明了强度及微观组织的影响规律及机理。结果
    表明:合金中时效强化相包括T1 相( Al2 CuLi)、兹忆相( Al2 Cu) 和啄忆相( Al3 Li)。Cu、Li 原子总分数及其比例增
    加,合金中时效强化相总量及T1 相比例大,合金强度较高。而Cu/ Li 原子分数比例较低,啄忆相比例增加,T1 相
    比例下降,合金强度降低。

    Abstract:

    Based on 18 Al-Li alloys with various Cu (3. 24% ~ 4. 16%) and Li (0. 94% ~ 1. 44%) con鄄
    tents, the influence of Cu and Li contents on the mechanical properties and microstructures of T8 aged Al-Li alloys
    with micro鄄alloying elements of 0. 4Mg, 0. 4Ag and 0. 4Zn was investigated. The strengthening effect and microstruc鄄
    ture variation were analyzed through total non鄄solution atomic fraction of Cu and Li and their atomic ratio. The
    strengthening precipitates consisted of T1(Al2CuLi), q忆(Al2Cu) and d忆(Al3Li). With increasing the total non鄄solu鄄
    tion atomic fraction of Cu and Li and their atomic ratio, the total amounts of precipitates and the proportion of T1 pre鄄
    cipitates were increased, the alloy strength was enhanced. Lower Cu/ Li atomic ratio led to an increase in d忆precipi鄄
    tates, and therefore lowered the alloy strength.

    参考文献
    相似文献
    引证文献
引用本文

李劲风. Cu、Li 含量对Mg、Ag、Zn 复合微合金化铝锂合金力学性能及微观组织的影响[J].宇航材料工艺,2015,45(2).

复制
分享
文章指标
  • 点击次数:
  • 下载次数:
  • HTML阅读次数:
  • 引用次数:
历史
  • 收稿日期:
  • 最后修改日期:
  • 录用日期:
  • 在线发布日期: 2016-11-28
  • 出版日期:
第十一届航天复合材料成形与加工工艺技术中心交流会 征文通知

关闭