一种耐高焓低热流环境隔热材料
作者:
作者单位:

北京航空材料研究院

作者简介:

李兴刚,1981 年出生,工程师,主要从事固体火箭发动机外防热材料研究。

通讯作者:

中图分类号:

基金项目:


Insulation in High Enthalpy and Low Heat Flow
Author:
Affiliation:

Fund Project:

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献
  • |
  • 相似文献
  • |
  • 引证文献
  • |
  • 资源附件
  • |
  • 文章评论
    摘要:

    采用模压工艺将耐高温阻燃硅橡胶和隔热填料RMX 压制成胶结片材,其密度为0. 56 g/ cm3,比 热容为1. 371 J/ (g·K),热导率为80 mW/ (m·K),拉伸强度为1. 87 MPa,断裂伸长率为25%。在高焓低热流 风洞考核环境下,厚度为1 mm 隔热材料试件界面平均温度为70. 7℃,试片表观完整、无龟裂。

    Abstract:

    High temperature resistant and rent burning silicone rubber and fillers were pressed into the adhesive sheet using the molding process. The material density is 0. 56 g/ cm3,specific heat is 1. 371 J/ ( g·k), thermal conductivity is 80 mW/ (m·K),tensile strength is 1. 87 MPa,and the elongation at break is 25%. At the wind tunnel environment of high enthalpy and low heat flow of certain type solid rocket motor,interface temperature is 70. 7℃ for 1 mm thick insulation material. And the apparent of specimens is complete with no cracking.

    参考文献
    相似文献
    引证文献
引用本文

李兴刚,张利军,胡润芝,钱 蕴,王兴斌.一种耐高焓低热流环境隔热材料[J].宇航材料工艺,2014,44(3):62-63.

复制
分享
文章指标
  • 点击次数:
  • 下载次数:
  • HTML阅读次数:
  • 引用次数:
历史
  • 收稿日期:2014-04-03
  • 最后修改日期:
  • 录用日期:
  • 在线发布日期: 2016-11-28
  • 出版日期:
第十一届航天复合材料成形与加工工艺技术中心交流会 征文通知

关闭