有机硅材料用于冲压发动机绝热层的研究
作者:
作者单位:

西安理工大学工程力学系

作者简介:

詹穹,1985 年出生,硕士,工程师,主要从事固体火箭发动机绝热层的研究。

通讯作者:

中图分类号:

基金项目:


Organic Silicon Material for Ramjet Adiabatic Layer
Author:
Affiliation:

Fund Project:

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献
  • |
  • 相似文献
  • |
  • 引证文献
  • |
  • 资源附件
  • |
  • 文章评论
    摘要:

    介绍了以硅树脂作为冲压发动机绝热层的基体材料,以YJ 短纤维或纤维织物作为增强材料的两 种绝热层配方的烧蚀性能。考察了YJ 短纤维的含量、硅树脂/ 纤维织物的质量配比对绝热层烧蚀率和工艺性 能的影响。结果表明:YJ 短纤维为4 份时,硅树脂/ YJ 短纤维/ 氧化锆配方的烧蚀与工艺的综合性能最佳,而 硅树脂与纤维织物的质量配比为1. 1 ∶1 时,硅树脂/ 纤维织物配方的氧乙炔烧蚀率最小,仅为15. 2 μm/ s。20 s 缩比发动机地面试验结果表明,两种配方绝热层均对冲压发动机实施了有效热防护。

    Abstract:

    This paper introduces using silicon resin as a ramjet engine insulation layer of matrix material, with YJ short fiber or fabric as reinforced two insulation formula ablative properties of materials. The influence of content of YJ short fibers and the mass ratio of silicone resin/ fiber fabric, on the insulation ablation rate and the process performance was studied. The results show that YJ short fiber is 4 phr, the comprehensive performance of ablation and silicon resin/ YJ short fiber/ zirconia formula was the best, and the mass ratio of silicone resin and the fabric is 1. 1 ∶1, silicone resin/ fiber fabric formulations of oxyacetylene ablation rate is the smallest, with only 15. 2 μm/ s. 20 seconds compression ratio engine ground test results show that the two formulations, insulation of ramjet engine implemented effective thermal protection.

    参考文献
    相似文献
    引证文献
引用本文

詹 穹,李 洋,方陆军,陈春娟,彭正贵.有机硅材料用于冲压发动机绝热层的研究[J].宇航材料工艺,2014,44(3):31-33.

复制
分享
文章指标
  • 点击次数:
  • 下载次数:
  • HTML阅读次数:
  • 引用次数:
历史
  • 收稿日期:2014-03-21
  • 最后修改日期:
  • 录用日期:
  • 在线发布日期: 2016-11-28
  • 出版日期:
第十一届航天复合材料成形与加工工艺技术中心交流会 征文通知

关闭