碳纤维复合材料孔加工质量试验研究
DOI:
作者:
作者单位:

北京卫星制造厂

作者简介:

通讯作者:

中图分类号:

基金项目:


Experimental Research on The Quality of The Hole-Making inCarbon Fiber Reinforced Plastic
Author:
Affiliation:

Fund Project:

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献
  • |
  • 相似文献
  • |
  • 引证文献
  • |
  • 资源附件
  • |
  • 文章评论
    摘要:

    碳纤维复合材料零件上存在大量的装配工艺孔,采用传统孔加工方式过程中容易导致分层、纤维
    撕裂等缺陷. 本文通过钻削和螺旋铣削方式加工碳纤维复合材料(CFRP),对比两种孔加工方法的加工质量,
    分析了缺陷存在的原因,发现在碳纤维复合材料上采用螺旋铣削制孔方式是可行的,对碳纤维复合材料孔加工
    工艺具有一定的参考价值。

    Abstract:

    There are many holes used for assembly in carbon fiber reinforced plastic (CFRP) parts, traditional
    hole-making method is subject to various damages such as delamination and fiber pullout. In this paper, drilling and
    helical milling CFRP are carried out, according to comparison of the machining quality of two hole-making method,
    the reason of the machining defect is analyzed. It was found that helical milling is a feasible method in hole-making,
    which has a broad applied value in the CFRP hole-making technology.

    参考文献
    相似文献
    引证文献
引用本文

王 震.碳纤维复合材料孔加工质量试验研究[J].宇航材料工艺,2013,43(6).

复制
分享
文章指标
  • 点击次数:
  • 下载次数:
  • HTML阅读次数:
  • 引用次数:
历史
  • 收稿日期:
  • 最后修改日期:
  • 录用日期:
  • 在线发布日期: 2016-11-28
  • 出版日期:
第十一届航天复合材料成形与加工工艺技术中心交流会 征文通知

关闭