超声速湍流导管烧蚀流场稳定性研究
DOI:
作者:
作者单位:

中国航天空气动力技术研究院,北京 100074

作者简介:

通讯作者:

中图分类号:

基金项目:


Stability of Ablative Flow Field of Supersonic Turbulent Duct
Author:
Affiliation:

Fund Project:

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献
  • |
  • 相似文献
  • |
  • 引证文献
  • |
  • 资源附件
  • |
  • 文章评论
    摘要:

    对超声速湍流导管烧蚀流场进行理论计算,选取了初始面积比为2. 0 和3. 0 的超声速导管,得
    到了在绝热指数为1. 1、1. 2 和1. 3 三个典型状态下总焓、马赫数、导管内压力、静焓及恢复焓随导管截面积加
    大的计算结果。研究表明:试验过程中总焓不变,但由于试验材料烧蚀导致导管的截面积加大将引起其余流场
    参数的变化,马赫数随导管的截面积加大而加大,其余参数随导管的截面积加大而降低,在导管截面积增大
    20%时,马赫数增幅在9%以内,导管内压力降幅在20%以上,静焓降幅在8%以内,恢复焓降幅在1% 以内,绝
    热指数的上升将引起导管参数增幅或降幅加大,初始面积比加大,将引起导管参数增幅或降幅减小。

    Abstract:

    The calculation was carried out on flow field of supersonic turbulent duct. Two supersonic turbulent
    ducts with initial area ratios 2. 0 and 3. 0 were calculated at three specific heat ratios:1. 1, 1. 2 and 1. 3. The results included the changes of total enthalpy, Mach number, pressure in duct, static enthalpy and recovery enthalpy with in crease of the cross area of duct. It shows the total enthalpy is constant in tests, but other parameters change with the increase of cross area of duct due to test materials ablation. Mach number increases with the increase of cross area,the other parameters decrease. When cross area of duct increases by 20%, Mach number increasing amplitude is less than 9%, the pressure decreasing amplitude in duct exceeds 20%, the decreasing amplitudes of static enthalpy and recovery enthalpy are within 8% and 1%. The increasing or decreasing amplitudes of parameters in duct are higher with specific heat ratio increasing and lower with initial area ratio increasing.

    参考文献
    相似文献
    引证文献
引用本文

张友华 陈连忠.超声速湍流导管烧蚀流场稳定性研究[J].宇航材料工艺,2010,40(4).

复制
分享
文章指标
  • 点击次数:
  • 下载次数:
  • HTML阅读次数:
  • 引用次数:
历史
  • 收稿日期:
  • 最后修改日期:
  • 录用日期:
  • 在线发布日期: 2016-11-28
  • 出版日期:
第十一届航天复合材料成形与加工工艺技术中心交流会 征文通知

关闭