制备工艺对W-10Ti合金组织的影响
CSTR:
作者:
作者单位:

航天材料及工艺研究所,北京 100076

作者简介:

通讯作者:

中图分类号:

TG14

基金项目:


Effect of Preparation Technology on Microstructure of W-10Ti Alloy
Author:
Affiliation:

Aerospace Research Institute of Materials & Processing Technology,Beijing 100076

Fund Project:

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献
  • |
  • 相似文献
  • |
  • 引证文献
  • |
  • 资源附件
  • |
  • 文章评论
    摘要:

    制备了W-10Ti合金,研究了冷等静压(CIP)压力、热等静压(HIP)温度、高温处理对W-10Ti合金组织的影响。发现CIP能明显提高装料密度,有利于后续的HIP成形和元素扩散。提高CIP压力和HIP温度,能提高W与Ti扩散程度,HIP在1 300 ℃时,纯Ti相完全消除。高温处理温度为1 300、1 400、1 500、1 700 ℃时,富Ti相含量先降低再升高,在1 400 ℃时降至最低,为5.18%。在超过1 400 ℃处理时,富Ti相会发生共析转变。

    Abstract:

    W-10Ti alloy was prepared,and the effects of cold isostatic pressing (CIP) pressure, hot isostatic pressing (HIP) temperature and high temperature treatment on the microstructure are studied.It is found that CIP can significantly increase the charge density,which is beneficial to HIP forming and element diffusion. The diffusion of W and Ti can be improved by increasing CIP pressure and HIP temperature.At HIP1 300 ℃, pure Ti phase is completely eliminated.When the high temperature treatment temperature is 1 300,1 400,1 500 and 1 700 ℃,the content of Ti-rich phase decreases first and then increases, and reaches the lowest at 1 400 ℃, which is 5.18%.When treated at more than 1 400 ℃,the Ti-rich phase underwent eutectoid transformation.

    参考文献
    相似文献
    引证文献
引用本文

杨亚飞,吕宏军,姚草根,李圣刚,王思伦.制备工艺对W-10Ti合金组织的影响[J].宇航材料工艺,2023,53(5):38-43.

复制
分享
文章指标
  • 点击次数:
  • 下载次数:
  • HTML阅读次数:
  • 引用次数:
历史
  • 收稿日期:2022-04-08
  • 最后修改日期:2023-08-30
  • 录用日期:2022-08-01
  • 在线发布日期: 2023-10-24
  • 出版日期: 2023-10-30
文章二维码