工艺制度对粉末TA15钛合金组织性能的影响
作者:
作者单位:

航天材料及工艺研究所,北京 100076

作者简介:

徐正,1995年出生,硕士研究生,主要从事粉末冶金研究工作。E-mail:747857703@qq.com

通讯作者:

基金项目:


Effect of the Processes on Microstructure and Properties of TA15 Alloy
Author:
Affiliation:

Aerospace Research Institute of Materials & Processing Technology,Beijing 100076

Fund Project:

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献
  • |
  • 相似文献
  • |
  • 引证文献
  • |
  • 资源附件
    摘要:

    研究不同保温时间和制粉方法对热等静压TA15钛合金的微观组织、拉伸性能和拉伸断口形貌的影响。结果表明:粉末TA15钛合金组织由等轴α-Ti、层状α-Ti和少量β-Ti组成。热等静压保温时间为20 min时粉末TA15钛合金已达到致密,随着保温时间延长到120 min组织逐渐均匀长大。采用等离子旋转电极法的粉末TA15钛合金的拉伸性能优于惰性气体雾化粉末TA15钛合金。拉伸断裂模式为韧性断裂,断口微观形貌为韧窝。

    Abstract:

    The effects of holding time and pre-alloyed powder manufacturing methods on microstructure, tensile properties and tensile fracture morphology was investigated for powder metallurgy (PM) TA15 alloys. In this work, hot isostatic pressing (HIPing) technique was used to densify the TA15 pre-alloyed powder. The results show that the microstructure of PM TA15 alloys is composed of equiaxed α grains, lamellas α grains and a little β grains. When the holding time is 20 min during HIPping, the PM TA15 alloys have gotten full densification. As the holding time extends to 2 h, the microstructure became coarser. The tensile properties of PM TA15 alloys with plasma rotating electrode process powder are better than those of PM TA15 alloys with gas atomization powder. The tensile fracture mode is ductile fracture, and fracture morphology appearance is the dimple.

    参考文献
    相似文献
    引证文献
引用本文

徐正,张绪虎,徐桂华.工艺制度对粉末TA15钛合金组织性能的影响[J].宇航材料工艺,2021,51(1):76-80.

复制
分享
文章指标
  • 点击次数:
  • 下载次数:
历史
  • 收稿日期:2020-11-30
  • 最后修改日期:2020-12-21
  • 录用日期:2020-12-01
  • 在线发布日期: 2021-02-19