基于锤击法的复合材料层合板振动理论及实验模态分析
作者:
作者单位:

作者简介:

通讯作者:

基金项目:

国家自然科学基金(11372220);天津市高校中青年骨干创新人才培养计划


Composite Laminates Vibration Theory and Experimental Modal Analysis Based on Hammering Method
Author:
Affiliation:

Fund Project:

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献
  • |
  • 相似文献
  • |
  • 引证文献
  • |
  • 资源附件
    摘要:

    基于实验模态分析理论,构建了复合材料层合板的模态实验理论及测试系统。首先制备了150 mm×80 mm×3.75 mm的碳纤维复合材料层合板,通过DH5922N动态数据采集仪提取了加速度传感器以及力锤所感应到的频响函数及激励信号。将频响函数导入DHDAS动态信号分析系统后获得复合材料层合板一阶及二阶固有频率分别为323.103和656.180 Hz,并测得对应频率下的各测点振型。结果表明,利用本文所提出的实验理论及所用设备可精确提取复合材料层合板的模态信息。

    Abstract:

    Based on the theory of experimental modal analysis, the modal theory and testing system of composite laminates is established. Firstly, composite laminates of 150 mm×80 mm×3.75 mm (length×width×thickness) were built-up. By using DH5922N dynamic data acquisition instrument, the frequency response function and the excitation signal sensed by acceleration sensor and force hammer are obtained. And frequency response function is analysised in the dynamic signal analysis system DHDAS. The first and second natural frequencies were 323.103 Hz and 656.180 Hz respectively, and the shift values of each measurement point corresponding to the frequency were obtained. The experimental results show that the experimental theory and the equipment used in this paper can be used to accurately extract the modal information of composite laminates.

    参考文献
    相似文献
    引证文献
引用本文

李菊峰,杨涛,杜宇,牛雪娟.基于锤击法的复合材料层合板振动理论及实验模态分析[J].宇航材料工艺,2017,47(1):25-28,36.

复制
分享
文章指标
  • 点击次数:
  • 下载次数:
历史
  • 收稿日期:2016-06-13
  • 最后修改日期:
  • 录用日期:
  • 在线发布日期: 2017-02-17