低温固化非热压罐成型树脂及其复合材料性能
作者:
作者单位:

航天特种材料及工艺技术研究所,北京 100074

作者简介:

许皓,1991年出生,工程师,主要从事航天特种材料及工艺技术研究工作。E-mail:843768317@qq.com

通讯作者:

中图分类号:

TB332

基金项目:


Properties of Low Temperature Curing Out of Autoclave Resin and Its Composites
Author:
Affiliation:

Research Institute of Aerospace Special Materials and Processing Technology,Beijing 100074

Fund Project:

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献
  • |
  • 相似文献
  • |
  • 引证文献
  • |
  • 资源附件
  • |
  • 文章评论
    摘要:

    通过DSC、红外光谱、流变仪和力学性能测试等方法,研究了3228树脂及T700/3228预浸料的性能。结果表明:3228树脂初始固化温度为67.9 ℃,峰值固化温度为89.5 ℃;在60 ℃时具有大于2 h的低黏度平台期,黏度值在20~30 Pa·s;温度大于65 ℃后表现出低温快速固化的特性;采用60 ℃预固化1 h,80 ℃固化3 h的非热压罐成型工艺方案,制备的复合材料具有较低的孔隙率和良好的力学性能。

    Abstract:

    The performance of T700/3228 prepreg was studied by differential scanning calorimetry(DSC), infrared spectroscopic,rheometer and mechanical properties testing.The result shows that the initial curing temperature and peak curing temperature are 67.9 ℃ and 89.5 ℃,respectively. The viscosity for 3228 resin at 60 ℃ is between 20 to 30 Pa·s and maintains more than 2 h.When temperature is above 65 ℃,the rapid curing characteristics is showed. The composite with low porosity and good mechanical properties have been prepared by adopt 60 ℃ procuring 1 h,80 ℃ curing 3 h as molding process plan.

    参考文献
    相似文献
    引证文献
引用本文

许皓,欧秋仁,张帅,唐中华.低温固化非热压罐成型树脂及其复合材料性能[J].宇航材料工艺,2021,51(1):50-54.

复制
分享
文章指标
  • 点击次数:
  • 下载次数:
  • HTML阅读次数:
  • 引用次数:
历史
  • 收稿日期:2020-06-29
  • 最后修改日期:2019-11-14
  • 录用日期:2019-11-15
  • 在线发布日期: 2021-02-19
  • 出版日期: 2021-02-28
第十一届航天复合材料成形与加工工艺技术中心交流会 征文通知

关闭