三种钻头钻削CFRP的制孔损伤对比
作者:
作者单位:

1.湖南科技大学机电工程学院,湘潭 411201;2.湖南科技大学机械设备健康维护省重点实验室,湘潭 411201

作者简介:

通讯作者:

中图分类号:

基金项目:

国家自然科学基金 No.51775184,No.51275168,No.51605161;湖南省自然科学基金 No.2015JJ5028国家自然科学基金(No.51775184,No.51275168,No.51605161);湖南省自然科学基金(No.2015JJ5028)


Comparison on Hole Damage of Drilling CFRP With Three Kinds of Drills
Author:
Affiliation:

1.School of Mechanical Engineering, Hunan University of Science and Technology,Xiangtan 411201;2.Hunan Provincial Key Laboratory of Health Maintenance for Mechanical Equipment, Hunan University of Science and Technology,Xiangtan 411201

Fund Project:

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献
  • |
  • 相似文献
  • |
  • 引证文献
  • |
  • 资源附件
  • |
  • 文章评论
    摘要:

    采 用二刃双锋角钻头、三刃双锋角钻头和圆弧形钻头在不同加工参数下钻削CFRP,对比分析了孔入出口质量(入口损伤、毛刺和出口撕裂),并采用毛刺存在角度来衡量毛刺的多少。结果表明:随着进给量的增大毛刺存在的角度(范围)α先减小后增大;综合考虑孔入口和出口质量(毛刺和撕裂因子),三刃双锋角钻头最适合钻CFRP。

    Abstract:

    In this paper,the two-edged double point angle drill,three-edged double point angle drill and arc-shaped drill were used to drill UD-CFRP under different cutting parameters.The hole entry and exit quality (entrance damage,burr and exit delamination) were analyzed.And the burrs exist angle (α) was used to measure the number of burrs.The experimental results show that the angle α decreases first and then increases with the increase of the feed rate.Taking into account the quality of the entry and exit (burr and delamination factor), the three-edged double point angle drill is most suitable for drilling CFRP.

    参考文献
    相似文献
    引证文献
引用本文

邱新义,李鹏南,陈安华,牛秋林,刘峰.三种钻头钻削CFRP的制孔损伤对比[J].宇航材料工艺,2019,49(1):68-71.

复制
分享
文章指标
  • 点击次数:
  • 下载次数:
  • HTML阅读次数:
  • 引用次数:
历史
  • 收稿日期:2017-10-10
  • 最后修改日期:2017-11-27
  • 录用日期:2017-11-27
  • 在线发布日期: 2019-02-18
  • 出版日期:
第十一届航天复合材料成形与加工工艺技术中心交流会 征文通知

关闭